There are additional ancillary costs not rolled into the above BOM. But I will kit all the boards based on this set of parts anyway, so this is the base cost for one unit. The diode and the 0 ohm resistors aren’t installed at the same time the 0402 resistors aren’t installed at all if the board is to be used for a projector build as they’d be unnecessary, etc. Now, not all of these parts are used in the same buildup. PCB, MM PCB10002 REV B, Simple iPad BreakoutĬonnector, DisplayPort, SMD, Molex 0472720001Ĭonnector, FFC, 51 Pos, 0.3mm Pitch, Molex 5022505191Ĭapacitor, Alum Elec, 100uF, 10V, TH, Panasonic EEUFR1A101ĭiode, Schottky, dual common cathode, 25V, 1A, TO-261, NXP BAT120C,115 So rather than keep my costs under wraps and provide you with a blackbox number, here is the actual amount that it costs me to build one of these boards, by component (in USD): Component ![]() Actually it just makes me happy that anyone is interested at all in what I’m doing. ![]() I’m not looking to make a huge profit of any of this. ![]() A lot of people have been asking about how much these boards cost, so it seems worthwhile to post a little something to clear this up.
0 Comments
Leave a Reply. |